IBM System/23 Datamaster: Difference between revisions

The ROM Operating System or symply ROS is the firmware of the System/23. It consists in a set of sixteen ROMs of 8KB each, for a total of 128KB. Each ROS ROM has a unique diagnostics identification code, which is determined by the outputs of two 74LS138 3:8 decoders. ROMs 02h and 09h are fixed in the memory map, where the rest are paged in the memory range 4000h-7FFFh. ROMs 0Eh and 0Fh are not present but the logic to select them is implemented even if there is no place to place them in the board; still, with an appropriate ROM adapter their space could be enabled to inject code into the system.

 

 

Regarding the diagnostics, every single ROS image contains its own reference inside the code. It is still not known at the moment of this writing but it is supposed to be part of the verification algorithm used by procedure PID 1200. Other important aspects to have in mind during the checks are that if the ROM identifier is inverted the memory is faulty. In case it is underlined, usually means that it is not present or detected. Usual causes for this fault are either power supply issues or memory select signals.

For most cases it is not necessary having the probe, as the same values that are outputted through the service port are also written in the video memory, displaying the passed tests and the errors encountered. However, as the same tests that check the video display controller are the same routines that initialize it, all the tests made before the initialization cannot be seen in the screen until passed. In case some of them failed the screen would not be initialized and therefore the results wouln't be seen. For this reason the probe is still needed.

 

 

[[Category:Computers of IBM]][[Category:Computers of the United States of America]]